While care has been taken in the preparation of the information contained in this web site, UCANFIX.COM and the UCANFIX NETWORK does not and cannot guarantee its accuracy. Anyone accessing this information does so at their own risk. It will be assumed that access indemnifies UCANFIX.COM and the UCANFIX NETWORK from any and all injury or damage arising from such use.
Some work must be done by licensed Professionals and work must be inspected by a local municipal or county or state inspectors.
Electrical box Installation
To install an electrical box turn the power to the circuit off at the main service panel. Test the wires for power using the circuit tester the tester should not glow if it does shut the power off to the correct circuit at the main service panel. Fasten the electrical box to a wooden framing member. Thread each cable through a cable clamp. Tighten the clamp 6 inches from the end do not over tighten. Over tightening can damage cables. Insert the cables into the electrical box and screw a locknut onto each cable clamp. Attach the copper ground wires together and screw to green screw on back of box. Attach black wires together with marretts then do the same to the white.